No Products in the Cart
Set of 4: Each product is sold as a complete set of four pieces, one piece for each wheel.
The Toyota Century is Japan's flagship — hand-built, rear-wheel drive, the car reserved for heads of state and executive transport. When Century owners modify with aftermarket wheels, the detail level of the center cap needs to match the vehicle. The floating mechanism keeps the logo upright as the wheel rotates, counter-rotating so the badge stays level. Set of 4. Measure your center bore before ordering.
You need one of your current caps, a ruler or tape measure, a sheet of paper and a pencil.
Tap your size to select it.
Pick the size closest to your number. A few millimeters either way is normal. 177.8mm (7") isn't available in Brushed or Polished Aluminum.
Start at the last whole number, then count the little lines past it. Each one adds 1/16 in. Example: 5 and 11 little lines is 5 11/16 in, our 145mm size.
Flip the cap over. Measure the raised inner ring that holds the metal clip, outside edge to outside edge, straight across the middle.
Don't measure the hole inside the ring or the wide outer cap.
Tap your back ring size to select it.
Got your numbers? Pick your logo and finish, then choose your back ring and outer size.
